62mac said...
Thanks for the kind words everyone,not my best surfing or waves but its a start.If you can't laugh at yourself well you sure can't laugh at others.
I want to get some more look back video then I'm going to face the camera facing the nose,I think it the way to film.

Kadi great to see you out and about mate

Obct great idea mate,not only will it sit nice and flush,it will be a very clean look unlike the gopro mounts.

obct said...
Good vid Mac, especially for a first effort, I know because I recently tried to take some footage with a new Muvi Cam I got, and I had to throw away every second of it because it was so bad. The problem is, I was hand holding it and I'm just not a good enough surfer to do that.

Speaking of which, I'm thinking of embedding a mount directly into the nose of the board using a modified leash plug.

I simply pushed out the stainless pin with a pin punch, cleaned up an 8M x 1.25 stainless set screw before covering it with PVA release agent (that's the blue stuff you see on the side of the screw).

Then for some strength, I threaded some fin rovings through the now empty pin hold and added a heap of finely chopped glass into the hole and the resin mix.

The used Q-cels in the resin mix (epoxy, because the only polyester I had was filler and that was too gluggy), along with some more finely chopped glass and poured it into the leash plug, then carefully push the set screw to the bottom, before plugging the pin holes to make sure all the resin did not fall out the sides.

Once it hardened, I just unscrewed the set screw and the came straight out leaving a perfect thread cut all the way to the base.

I was going to drill and tap, but I decided to do it this way because the thread would go deeper, even a plug tap would not go as deep.




Not sure yet if I'm going to use it, I first have to decide what sort of mount to put on top of it after I set it in the board.

62mac said...
Kadi just learning to turn the thing on is a good start for an old bugger like me

62mac said...
Picture post them up CC.

CrispCritter said...


Hi OBCT,
If it helps at all, you can get adaptors for most Muvi cameras that allow you to use the Gopro surfboard mounts. this allows you to use the stick on mounts that are unbelievably strong, or if you want a flush look you can set a FCS fin plug (just one) into the nose of your board, then there is another mount that comes as an extra with the stick on kit that you can put into the fin plug and secure it just like a fin, so its real easy to put on and take off, and you hardly notice the plug when the mounts out.
I can post some pics of both set-ups if you like.

Blair365 said...
great video Marty well done

CrispCritter said...


And kadilak, just be careful with home made stick on jobs, the lifeguards at my local all have Gopros, and they didn't pay for any of them!!!

chrispychru said...
Our buy a Contour...they float when they get ripped off ya board yeeew

chrispychru said...
Our buy a Contour...they float when they get ripped off ya board yeeew

obct said...


The easiest way to do it would be just to buy the Muvi board mount, JB Hi-Fi have them for $34, that's cheap compared to what Gopro want for a separate board mount, matter-o-fact, gopro seem to have a scorched earth pricing policy for all their accessories.

He's the strange thing, I may get the Muvi board mount and still sink the plug in the nose, why?

Because by using the Muvi mount without the adhesive, I can easily go back to having a perfectly smooth board for the 99.999% of the time that I'm not using the Muvi.