robbo1111 forum posts in last 60 days

+1 for the NSI stick on inserts. Cleanliness and prep is the key to good adhesion. I've had a front footstrap on my SUP foil board for 5 years and one insert finally gave way last week after a wipeout with my foot stuck in the strap. I'll glue it back on with some JB weld.
I also have the inserts on my foil drive board and they're still going strong.

Naish and NP the best I have used. PPC, Ozone, Ensis, KT all have their various issues but to be fair to them all none have ever leaked.

I don't own the PR but I have shortened the lines on my SAB foil Ala. Rather than cutting and splicing I have shortened each leader line by 8 inches via figure 8 knots as per photos below. On water testing showed a huge improvement in my ability to pack down the wing without effecting the power or flying performance. I also thought that the knots and doubled up lines would cause tangling issues but so far so good. Maybe one day I'll end up splicing all of the lines but at this stage I don't see the point.