2 posts
The screw in plug itself is metal and the vent with the hole and thread is plastic. I can't post a photo as I am a new member.
The vent seems to sit in a cut out hole under the outer casing of the board, so that the outer casing just cover a little over it. So I think I have detached it due to over tighting and thus it is now wobbling under that and there is a smal gap between it and the outer casing of the board
2 posts
Hi, I have just over tighten the screw in =my vent plug on my foil board. There is no damage to the plug or the screw, but it seems to have detached from the board and now wobbles.
Does that mean water can get in ?
Also how should I fit this ? Should I just try and apply epoxy resin around the rim of the vent to try and reattached it to the main part of the board ?
