Select to expand quote
KiteBud said..
Did both blowouts occur on the same end ?
If so, there could be an issue with the dacron seam alignment on that side.
If not, then most likely incorrect bladder installation. The end cap method is more prone to this.
Assuming the bladder is not too short, then it's most likely due to a twist or bunching at the end of the bladder.
Make sure the person installing the bladder is familiar with this installation method.
I'm sure Ryan AKA the Sail Doctor (Cornishryan on Seabreeze) will share some good insights on this one.
Yep indeed I can.
In my experience I see poor installation as the issue with the end cap method. I see no other reason it would fail. Likely the shop has installed with a twist. I've seen this a few times when customers have installed the bladders thinking it's super simple.
Personally I don't think it will be a dacron issue knowing the brand and process of manufacture.
