copperdog1 said..
Recently got a go pro camera and I don't have a FCS mount on my board - can you get a FCS mount installed on the board or just go with the stick on mount?

It's possible to get your board cut open and have a mount installed but it would probably cost $150 minimum and my theory is you should never compromise the integrity of the board's construction if you don't have to. IMO, you would be far better off with the stick on mount. Get a foam float for the GoPro if you are worried about losing it in surf.

I have both and the stick on ones have never come off yet.

colas said..
Be careful with the stick on mount. I know many people who have been cut open on the face and hands by falling on it, its edges are hard enough to do a lot of damage to wet skin.

True, but falling on a mounted camera hurts more - I have done that a couple of times - ouch

Buy a roll of the Nito silver/grey duct tape and tape a square on the board of about 20cm square using about six strips slightly overlapping.

Then get the black plastic mount that the camera came mounted on the the original GoPro packaging (hopefully you didn't throw it out) and tape it to the square of tape that's stuck on your board using many overlapping strips of tape.

Run a safety string to somewhere just in case.. I've done this dozens of times and never had a problem.. Maybe avoid waves over head high.

Use a hair dryer to warm the tape when removing to avoid any paint pealing issues.