Take it back to where you bought it from, that shouldnt happen at all - its a Safety fault that could land you in deep ***t if it unhooks in a launch area...

They should be able to get a replacement bar for you or a stronger model one to keep us all safe

If your still living in the land of "Far Far Away" I mean Albany put a picture of the bar up - someone may have one laying about ??

Or temporarily:
On the Donkey Bit - just bang a bit of wood dowel or any hard tubing up to where it sits (pulled vertically) against the hook. Only use a short piece so either side has flex to get in and out of the hook easy...

Hope this helps :)

BurkeyBoy said...

My mystic Warrior hook was very shallow and could unhook easily. I tried tapping gently with a hammer. It barely shifted so I ended up using a lump hammer and bashing the living daylights out of the thing. Eventually it bent to a better shape and I have no concerns as to the strength of it. If you have no luck replacing with the manufacturer don't be scared to give it a solid pounding.

Heh BB, was that a Mystic Warrior 1 Harny you had? As that is what harness I have been using or went back to of late and I had my Chicken Loop and Donkey Dick pull out of the hook about a week ago which led me to doing a bit of unexpected unhooked riding Which I never experienced while using my Dakine Harness.

I must admit I had my harness a bit loose as I was keen on it trying to swivel aound on my hip a bit for better down the line toeside wave riding. After I got back to the beach and re rigged I noticed the whole hook and hook pad was tilted upward pretty serverely. Since then I have done my waist straps and the lower strap up alot tighter and have not experienced the same problem, yet

I have noticed my Dakine Harness's Hook has a bit more bend down in it than my Mystic Harness Hook. The reason I'm asking maybe I need to bend the hook over a bit more on my Mystic Harny, like you did for a bit more reassurance, as unhooked riding on my 12 is a bit of an experience in 25 knot + conditions

Lots of people in sheds hitting kitesurfing harnesses with hammers and wood.

sonya rachel said...

All fixed, managed to place the hook over a peice of timber and wedge it in the vice, placed a adjustable spanner on each end and just bend it back (took a bit of effort) but no smacking with the hammer needed.

now you have just made it soft and it will bend and snap
just go buy a new one
how much is a new bar $40??